Buying online JET 708404 JBOS-5 5-1/2 Inch 1/2 Horsepower Benchtop Oscillating Spindle Sander with Spindle Assortment, 110-Volt 1 Phase Updated - Jet's spindle sander, with comparisons to Delta'sBy RKM*Skip to bottom of review for update*I've had a Delta BOSS spindle sander for ~5 years and it worked well until the motor burned out. Repairing it would cost almost as much as a new one, and even if repaired its longevity was questionable (other than that I've been pleased with its performance), so I looked for a replacement and settled on the Jet. I've used the Jet and it does the job intended. However, it has some areas in which it could be easily improved. Following are some comparisons between the Jet and the Delta. 1) The Jet is slightly quieter than the Delta, but not a lot - neither is a loud tool.2) The Delta's round table is larger than the Jet's square one. The Jet's table is beefier (the Delta's never showed any tendency to flex).3) The Delta's base is plastic, while the Jet is all metal. The feet for the Delta are molded into its base, with non-skid rubber inserts attached - all four of the molded feet are cracked, though ... » More Information about JET 708404 JBOS-5 5-1/2 Inch 1/2 Horsepower Benchtop Oscillating Spindle Sander with Spindle Assortment, 110-Volt 1 Phase.Sunday, June 26, 2011
Jet 708404
Buying online JET 708404 JBOS-5 5-1/2 Inch 1/2 Horsepower Benchtop Oscillating Spindle Sander with Spindle Assortment, 110-Volt 1 Phase Updated - Jet's spindle sander, with comparisons to Delta'sBy RKM*Skip to bottom of review for update*I've had a Delta BOSS spindle sander for ~5 years and it worked well until the motor burned out. Repairing it would cost almost as much as a new one, and even if repaired its longevity was questionable (other than that I've been pleased with its performance), so I looked for a replacement and settled on the Jet. I've used the Jet and it does the job intended. However, it has some areas in which it could be easily improved. Following are some comparisons between the Jet and the Delta. 1) The Jet is slightly quieter than the Delta, but not a lot - neither is a loud tool.2) The Delta's round table is larger than the Jet's square one. The Jet's table is beefier (the Delta's never showed any tendency to flex).3) The Delta's base is plastic, while the Jet is all metal. The feet for the Delta are molded into its base, with non-skid rubber inserts attached - all four of the molded feet are cracked, though ... » More Information about JET 708404 JBOS-5 5-1/2 Inch 1/2 Horsepower Benchtop Oscillating Spindle Sander with Spindle Assortment, 110-Volt 1 Phase.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment